Nickel Alloy 15k Quick Test Sub Wireline Pressure Control Equipment

Nickel Alloy 15k Quick Test Sub Wireline Pressure Control Equipment

5K Wireline Quick Test Sub Wireline Pressure Control Equipment

Ⅰ. Introduction

During Wireline operations it is necessary to break the quick union between the lower lubricator and the BOP to remove the tools within. When this joint is reconnected it is normal practice to fill and pressure test the entire lubricator system prior to opening the wellhead valve. The Wireline Quick Test Sub allows for only the joint that was broken to be tested, without filling the whole lubricator system, saving a substantial amount of time and large volumes of expensive test fluid, as well as alleviating the problems associated with dumping test fluids into the well.

II. General Technical Parameters

OTIS Quick Union

Ⅲ. Maintenance

After using this product every time, check whether the thread, Sealing surface and O-ring are damaged. If everything is normal, apply lubricating grease to the thread and sealing ring, and take protective wire for storage. If any damage is found to the O-ring or sealing surface, the

manufacturer shall be contacted in time for repair and replacement.

Quick Test Sub Wireline

15k Wireline Pressure Control Equipment

Nickel Alloy Quick Test Sub

Nickel Alloy 15k Quick Test Sub Wireline Pressure Control Equipment Images